Skip to main contentSkip to footer

Rural Fencing: Start With The Stock, Not The Wire

No Comments
Timber strainer post and wire mesh rural fence across green paddocks near Geelong

Most rural fencing problems do not start with the wire. They start with an order placed before anyone has worked out what the fence is meant to do. A boundary line on a lifestyle block, a sheep paddock and a horse yard can all sit on the same property, and each one asks for something different from the posts, the mesh and the gates.

This guide works through the questions worth answering before you put together a rural fencing order around Greater Geelong, from the Bellarine to the Golden Plains, so the materials you collect match the job in front of you.

Start with what the fence has to hold

The animal behind the fence shapes almost every other decision. Sheep and goats test the bottom of a fence and look for gaps to push through. Cattle lean and rub, so the fence needs to stay tight under weight. Horses are large, fast and easily injured, which is why many owners avoid barbed wire around them and favour fencing that is highly visible.

If the fence is simply marking a boundary with no stock involved, the brief is different again. Write down what each fence line needs to do before you think about products. It makes the conversation with your supplier much shorter and the order more accurate.

Know the main rural fencing materials

Rural fencing uses a fairly small set of components, combined in different ways:

  • treated pine posts, including heavier strainer posts for ends, corners and gateways
  • steel star pickets for intermediate support along the line
  • hinge joint or ringlock mesh for stock that needs a continuous barrier
  • plain high tensile wire for strength over long runs
  • barbed wire where it suits the stock and the property
  • galvanised farm gates sized for vehicles, machinery or people

Our rural fencing supplies range covers each of these, and the right mix depends on the stock, the length of the run and the ground it crosses.

Strainers and ends carry the load

A wire fence is only as tight as the posts holding each end. Every corner, change of direction, gateway and long straight run needs a solid end assembly, because that is where the tension from the wire is taken. When a rural fence sags, the cause is often an end that has moved rather than the wire itself.

Post depth matters for the same reason. Ground conditions around Geelong range from reactive clay to sandy coastal soils and rocky volcanic country, and each behaves differently once a post is loaded. Our guide on how deep fence posts should go explains the factors that affect it. For anything unusual, such as very soft ground or steep country, get advice suited to your site.

Choose timber that suits ground contact

Treated pine is graded by hazard class under Australian Standard AS 1604.1, and the class tells you where the timber is suited to be used. WoodSolutions describes H4 as suitable for in-ground or continuously damp, non-critical uses such as fence posts and landscaping, while H5 is intended for critical in-ground uses such as retaining walls and piles. Check the treatment class on any timber that will sit in the ground, and ask if you are unsure which one suits your fence.

Plan the gates before the fence

Gates are easy to treat as an afterthought, but they decide how well a property actually works. Think about the widest thing that needs to pass through, whether that is a ute and trailer, a tractor or a truck delivering feed. Place gates where stock naturally move, near water and laneways, and avoid putting them in low spots that turn to mud through winter.

Gateways also need strong posts on both sides, because a swinging gate puts constant load on its hanging post. If the entrance is the part of the property people see first, a custom gate can suit the driveway while farm gates handle the paddocks.

Check the boundary before you replace it

Many rural fencing jobs involve replacing an old boundary line shared with a neighbour. In Victoria, boundary fencing between neighbours is covered by the Fences Act 1968, which sets out how costs and notice are handled. Our article on who pays for a boundary fence in Victoria walks through the basics. Talk to your neighbour early and agree on the type of fence before materials are ordered.

Measure the run, then build the list

A simple sketch of each fence line saves time and waste. Mark the total length, every corner and change of direction, each gateway with its width, and any dips, creek crossings or rocky sections. From that, a supplier can help you work out post numbers, wire or mesh rolls, strainer assemblies and gates. Ordering in one go also keeps the materials consistent along the line.

Think about access and delivery

Rural fencing materials are heavy and bulky, so plan where they will be dropped and how they will reach each fence line. A dry, level spot near the start of the run is ideal, with room for a truck to turn. If paddocks are soft after rain, it is worth timing the order for drier weather so materials are not left sitting in mud.

Frequently asked questions

What is the difference between hinge joint and ringlock mesh?

Both are woven stock fencing meshes with horizontal and vertical wires. They differ in how the wires are joined at each crossing point. Ask your supplier which suits your stock and the way you plan to tension the fence.

Do I need strainer posts on a short fence?

Yes. Any wire fence needs solid ends to hold tension, whatever its length. Corners and gateways also need strainer posts, because they carry load from more than one direction.

Can I use star pickets instead of timber posts?

Star pickets are commonly used as intermediate supports along a fence line. Ends, corners and gateways usually rely on heavier timber strainer posts that can take the tension of the wire.

Is barbed wire suitable for every type of stock?

No. Many horse owners avoid barbed wire because of the risk of injury, and some properties prefer plain or mesh fencing near yards and laneways. Match the wire to the animals you keep.

How do I work out how much rural fencing material I need?

Start with the total length of each fence line, the number of corners and gateways and the type of stock. With those details, our team can help you work out quantities before you order.

Planning a new fence line on acreage?

Bring your measurements, a rough sketch of the paddocks and a note on the stock you run, and the Barwon Fencing Supplies team can help you put together a rural fencing order that suits the property. Get in touch before you start so the posts, wire and gates are ready when you are.

Previous Post
Fencing A Sloping Block: Stepped Or Raked?
Next Post
Bushfire Fencing: What Testing Shows About Each Material

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed

Latest Updates